Cast Iron Wheel for Antique Singer Treadle (Foot-Powered) Sewing Machine Frame

Description

My husband and I have owned and restored over 1000 antique and vintage Singer sewing machines, and along the way we have accumulated a stock of old Singer parts. The parts aren’t doing anyone any good sitting in our workshop, so we have decided to send them on to where they’re needed.
The Singer Company manufactured treadle (foot-powered) sewing machines for about 100 years, from the 1850s until the 1950s. The foot pedals and the various frame parts on early treadles were made from cast iron, and so were the wheels. We often come across treadle frames with a missing wheel, and maybe you have, too.
The dimensions of this wheel are
:
Diameter
:
just a little more than
one-and-one-quarter inches
Width (measured at the center hub)
:
nine-sixteenths of an inch
Width (measured at the outer rim)
:
one-half of an inch
Center hole for the axle
:
one-quarter inch, and the original quarter-inch axle shown in the photos comes with the wheel
Note:
This wheel measures one-half of an inch across at the outer rim. The oldest Singer treadle frames had wheels that were slightly wider at the rim than this one, measuring nine-sixteenths of an inch instead of one-half, and the newest Singer treadles had wheels that were slightly narrower, measuring three-eighths of an inch at the rim. In both cases the difference is so small that it's hardly noticeable, especially as the wheels are at floor level.
These things are easy to install but you do have to be careful because old cast iron is very brittle and easily broken. The trick is not to force the axle through your frame. Singer inserted a red-hot axle through the frame and wheel and then used a press to flatten one end of the axle to hold it in place. The trick to removing or installing the axle is to use a file to reduce the diameter of the axle on the flattened end so that it will slip easily through the holes in the frame.
Do not try to hammer it through!
Reduce the diameter with a file until it just slips through. You can see how my husband did this on the right end of the axle shown in photo three.
When you install this wheel and axle, use a dab of Gorilla Glue or something similar to hold the filed end of the axle in place in the frame.
I know this sounds a little bit complicated but it really isn’t hard to do.
This wheel and axle will also work on some treadle frames manufactured by companies other than Singer. Just measure the opening in the “fork” where the wheel has to go to figure out if it will fit.
Important:
We have five wheels and axles available as this is written, so the parts you receive will probably not look like the ones in the photos, but the age, authenticity, and quality will be the same. These parts have been cleaned but not polished so they will match the patina of most of the antique treadles out there. Use 0000 steel wool to remove the rust and brighten them up if you prefer that look.
Please ask if you have questions! We are happy to help you.
We invite you to take a look at our other eBay listings. We are selling many interesting and useful things.
All of our goods are unconditionally guaranteed. If you are not completely satisfied with this item when it arrives at your home, send it back and your money will be cheerfully refunded.
Thank you for looking in.